[WriteLog] How to make Writelog see MMTTY????

[Gary AL9A]

Ross,

The problem most likely is not with WriteLog, but with some settings in 
MMTTY.  I believe you said you are running XMMT.ocx as the TU type and 
apparently you have set the TNC in the Setup XMMT.ocx window to point to 
your MMTTY.exe location.  Now click on the XMMT Setup... button in the lower 
left corner of this window.  This will bring up the MMTTY setup window.  On 
the TX tab check the PTT & FSK box to select either your port number or 
EXTFSK at the bottom of the list if you are running AFSK rather than FSK.

Next click on the Radio command button.  In the Commands section note the 
little box "xx=".  This is to enter the hex code of your radio.  It must 
match the radio's hex address.  I'm not sure what if anything needs to be 
done for your 6700 in the other boxes.  In the Group box there is a drop box 
that lists several different brands and models.  The 6700 is not among them. 
In my case my radio is the IC-7600 and the Model selection is Icom CI-V and 
the Group is set to Icom xx=addr 01 - 7F, menaing the xx= hex address must 
be in the range of 01 to 7F.  Afraid I can't help you much more on this tab.

On the Misc tab check the TX Port area.  If you are running AFSK, check the 
Sound button.  If running FSK check the COM-TxD(FSK) button and then click 
the USB Port button and select item C: Limiting speed.

The final thing to check is the SoundCard tab.  This lists all the audio 
devices on your machine for Reception and Transmission.  Make sure the 
correct sound card choices are made for your desired setup.  The lists are 
numbered sequentially beginning with 0 for the first item in each list. 
After selecting the ones you want make note of their number position in the 
listings and then go back to the Misc tab and make sure the Device 
Identifiers box shows the correct RX and TX audio choice numbers you 
selected on the SoundCard tab.

That's all I can think of at the moment to get WriteLog and MMTTY working 
together.  Good luck.

73,
Gary AL9A

-----Original Message----- 
From: Ross Biggar
Sent: July 13, 2015 7:36 PM
To: writelog at contesting.com
Subject: [WriteLog] How to make Writelog see MMTTY????

Thanks to Neal Campbell, he has confirmed that MMTTY on my setup works 
perfectly and the 6700 transmits a correct RTTYsignal.
But the "interface" between Writelog and MMTTY does not work, for some 
reason Writelog does not key MMTTY,
either in the macros or from the keyboard.
So how does Writelog tell MMTTY to transmit? and importantly what part of 
the connection do I need to fix to get writelog working correctly.

Regards to all
Ross
ZL1WN
_______________________________________________
WriteLog mailing list
WriteLog at contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/