[WriteLog] Band Change Question!

[Darren Collins (G0TSM)]

This has been mentioned several times over the years and affects the 
FT2K, 5K, 9K etc. I recall the problem is that Writelog doesnt issue the 
'BS' CAT command when Writelog QSYs the radio. The correct sequence of 
CAT commands sent to the radios should be....
BSxx - changes radio to the desired band (band stack registers change 
ANT, IPO etc)
MDxx - changes mode on radio
FAxxxxxxxx - changes frequency on radio

Writelog only sends FA and MD so when QSYing your IPO, ANT, ATT settings 
etc will not change.

73 Darren G0TSM / M7X

On 14/09/2015 16:48, k2qmf at juno.com wrote:
> Hello All,
>
> I am using a Yaesu FTdx5000 with Writelog
> for contesting.
>
> I have my FTdx5000 set up for different "IPO" settings for
> different bands. (IPO1 for 40, AMP1 for 20,etc.).
> Also different antennas for different bands!
>
> Now when I, for instance, go from 40 to 20 using
> Writelog spot window these settings follow the
> band change.  In other words  when I get to 20
> the IPO and antenna settings stay on the 40 meter settings!
>
> I hope I have made myself clear enough?
>
> Any help or suggestions very much appreciated!
>
> Anyone else have this issue??
>
> Thanks in Advance....
>
> 73,
> Ted  K2QMF
>
> ____________________________________________________________
> Buffett’s New Enemy
> Buffett just confirmed his worst fear. Click here for his warning.
> http://thirdpartyoffers.juno.com/TGL3141/55f6ecd286ac06cd27f7ast04vuc
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/