[WriteLog] ports

[Courtney Judd]

hey Gary, device manager in WIN 7 says under Ports: ELTIMA Virtual 
Serial Port (COM3) is working properly. MicroHam router shows Com3 
assigned to CAT from ft2000d showing the correct freq read out and mode 
from the rig, but also says closed. Doing the normal setup from PORTS 
drop down menu in V12.. I put in for COM3 Ft2000 and 4800, click on 
apply and message pops up com3 is not available. This worked fine in 
V11. I am at a loss as to what to do or look at now. Only signal on 10 
right now is Kh6LC... kinda lonely! In INI file CommSlot1=1 and so on 
down to 4.... RIGS shows Com3:=4800,n,8,2   ... You would think that 
this would be simple to sort out but I am out of ideas! To get thru the 
contest I just set the freq to show 28000... guess that will have to 
do.  Hope you get some openings up there! Cort

> Gary Senesac <mailto:al9a at mtaonline.net>
> Friday, February 19, 2016 6:01 PM
>
> Cory,
>
> What does Device Manager show for Com3?
>
> Gary AL9A
> Sent from my Kindle HDX
>
>
>
> On February 19, 2016, at 2:14 PM, Courtney Judd <k4wi at k4wi.net> wrote:
>
>
> hey Gary, thanks for the help.... I already have V12 help printed out 
> local printer did for me.... but problem today is when i open the 
> PORTS  from the drop down menu it shows the 4 ports 1-4... I select 3 
> ... add FT2000 in rig spot, 4800 ,  hit apply and message comes up com 
> 3 is not available.. try to save and open again and all is gone. My 
> microHam router shows cat=com3, reads mode and freq correctly(will 
> change as move the dial) but says port is closed. In INI file shows 
> under RIGS Com3=4800,n,8,2. Under PORTS in INI shows 
> Comm3RigManager=(D0DE9422-0517-11D4-9D1B-00105AA43DDF) ,  
> Comm3XmitControl=ALWAYS
>
> any thoughts? router sees rig but nothing working with writelog, Cort
>
>
>
>