[WriteLog] K3, Writelog V12, Windows 10 64, Prolific USB-serial adapter

[Tom Sneden]

Thanks to Jeff, W6KI for providing me with the solution AND all of the
others who tried!!

Jeff's solution was in the K3 setup menu, there is a setting called
PTT-KEY. Make sure it is set to OFF-OFF.

That took care of my problem.

Thanks to all!

73 de Tom, K6VCR

On Mon, Jun 20, 2016 at 1:16 PM, Tom Sneden <tsneden at gmail.com> wrote:

> New to WriteLog and having problems interfacing it to my K3. I'm not
> trying to do anything fancy yet.
> Computer has no problems connecting to K3 direct for updates and such.
> My LP-Pan with NaP3/LP-Bridge works perfectly. This has been taken out of
> the loop while troubleshooting the WriteLog issue.
>
> Computer is connected directly to the K3/P3.
> WriteLog setup: Com Port 4
> CW: not checked
> DVK: greyed out
> Rig Type: K3
> Baud Rate: 38400
> Poll: is checked
> Comm Ptt: no
> DVK type: Windows sound board
> CW Keyer type: blank
> So2R Control: none
>
> Symptom:
> With WriteLog running (displaying the proper band, mode and frequency in
> the lower left window) everything works as it should until I switch bands.
> As soon as I press the band switch button on the K3, the K3 changes bands
> and goes into transmit and is unresponsive to any button pushes with the
> exception of powering down the radio OR closing down WriteLog (which stops
> the transmission) but then the K3 still needs to be powered down and
> restarted before it works correctly.
>
> My end goal is to use the K3 with the LP-Pan/NaP3/LP-Bridge with WriteLog
> for logging and voice keying
>
> Any suggestions would be greatly appreciated!
>
> 73 de Tom, K6VCR
>