[WriteLog] Writlog Remote setup questions

[Gordon LaPoint]

On 12/29/2019 17:12 PM, Wayne wrote:
>> Tom,
>>      I am just using the remote software with the "Soft win 1" slot to
>> get the virtual front panel to the K3.  This works fine, the problem
>> is in the WriteLog "QSO Entry" panel, "Radio" button, the only choice
>> I get is "Manual entry".  If I go to the "setup-WriteLog
>> Options-Ports" page the com port selection is not showing the "Soft
>> win1" or "Rem Slot 1", just com ports.  I don't have another K3, etc.,
>> just was going to use the virtual front panel of the "Soft win X" type
>> of connection. I was just trying to get anything working for the first
>> time, then I would worry about a "Front panel" for the radio.
>> Gordon - N1MGO
> You probably missed the final control site setup instructions way down
> at the bottom of this page:
>
> https://writelog.com/remote-control-setup-step-3-rig-control
>
> Wayne
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/

Wayne,

     Your correct!   I missed setting the "Rig Type" to "WriteLog 
Remote"   Its all working now!

Now off to learn what else I need to run the system remotely!

Thanks!

Gordon - N1MGO