[WriteLog] SDR questions

[Gordon LaPoint]

Gert,
      This got it working!   The secret was the bandmap window size, I 
had it too small.
Thanks for the help.
Gordon - N1MGO

On 1/20/2020 10:37 AM, Gert Meinen wrote:
> Gordon,
>
> Select setup; Writelog options; SDR Setup; at IQ Source choose IQ provided via ExtIO.
> Click Center Frequency Setup and in the "Writelog supports SDRs configured in the following way window"
> At "SDR is sampling RF from antenna"  check: Tunable SDR (EXTIO to select) sharing antenna on configured rig.
> Click next and fill in the comm.Port which your rig is using to communicate with Writelog. Click Select ExtIO and point to the folder where your
> ExtIO-SDRplay_RSP1.dll is located this should be in the SDRplay folder in Program Files.
> Click next 3x and you're back in the Writelog Options window check Run all SDRs and OK and the SDR starts running in the bandmap. Make sure you have the bandmap window wide enough (I have my bandmaps vertical) if you have set the width too small the Waterfall display will not be displayed.
>
> Hope this helps.
>
> 73 Gert, PA3AAV
>
> -----Oorspronkelijk bericht-----
> Van: WriteLog [mailto:writelog-bounces at contesting.com] Namens Gordon LaPoint
> Verzonden: maandag 20 januari 2020 12:17
> Aan: writelog at contesting.com
> Onderwerp: [WriteLog] SDR questions
>
> I have an RSP1 connected to my TS-590sg DVR output.  It works fine with
> HDSDR to provide a bandmap.  How do I setup WriteLog to use this as its
> bandmap SDR?
>
> Thanks,
>
> Gordon - N1MGO
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>