[WriteLog] CW Problems.

[Gordon LaPoint]

Joe,
    Thanks,  Are you talking about on the radio control port (COM18 in 
my case, the USB port) or the COM port used for PC generated CW/PTT/FSK, 
(Com7 in my case)?  I'm not using the same port to control the radio and 
send cw/ptt.
Thanks,
Gordon
On 5/2/2021 10:57 AM, Joe Subich, W4TV wrote:
>
> The standard Kenwood definition asserts RTS unless you are using it
> for CW. Look at the help file for information on preventing the
> rig driver from asserting RTS (and DTR) - note it involves editing
> Writelog.ini.
>
> 73,
>
>   ... Joe, W4TV
>
>
> On 2021-05-02 9:47 AM, Gordon LaPoint wrote:
>> Hi,
>>
>>     I'm setup for the NEQP, SSB works fine.  when I switch to CW the 
>> radio keys and stays keyed, can not find what I have setup wrong.
>>
>> Radio - Kenwood TS590sg   Ports set to COM18 115200  - works fine, 
>> tracks radio frequency/mode
>>
>> CW - COM 7  DTR= CW  RTS= PTT
>>
>>
>> CW Options:
>>
>> PTT Control (CW Mode ONLY)   None (QSK)   selected (tried "as 
>> specified in Ports", no difference)
>>
>> PTT to CW delay 0
>>
>> PC generates sends CW space on startup  - Checked  (also tried 
>> unchecked - no difference.
>>
>>
>> What else should I check?
>>
>> This used to work, so don't know what changed except upgraded to 
>> 12.59F , so downgraded to 12.56c, no change.
>>
>>
>> The same hardware setup works with N1MM and DX Labs, so I know the 
>> hardware is good!!!!
>>
>> Thanks,
>>
>> Gordon - N1MGO
>>
>