[WriteLog] RX issue with WL and FlexRadio 6400

[Alessandro - I2SVA]

Hi Don,
yes, that's done.
As a matter of fact if I shut down the RTTY window(s) and open the CW window it shows the same white noise but, if teh CW signal is strong and clear, does some decode.
..

Alessandro I2SVA


Il giorno 20/01/23, 21:20 "Don Hill AA5AU" <aa5au at bellsouth.net> ha scritto:

    You say "WL is properly configured."

    Did you set the RX soundboard in the WL Soundboard mixer control?

    Don AA5AU

    -----Original Message-----
    From: WriteLog [mailto:writelog-bounces at contesting.com] On Behalf Of
    Alessandro - I2SVA
    Sent: Friday, January 20, 2023 7:35 AM
    To: writelog at contesting.com
    Subject: [WriteLog] RX issue with WL and FlexRadio 6400

    Hi all,
    I am trying to configure RTTY on WL 12.68H together with Flex 6400 (v3.3.33)
    on a Windows 10 pc.
    FlexRadio 12.61b driver is installed and WL is properly configured.
    MMTTY and 2Tones instances are configured and running.
    On TX side is all ok.
    On RX side (both MMTTY and 2Tone), the level seems too high and in any case
    the RTTY tones are not visible (it looks like white gaussian noise); the
    noise is related to the active slice with no decode.
    I cannot find any way to sort out from this issue.

    Anyone is facing the same problem and can help me? Any parameter to
    set/change in the Flex 12.61b driver?

    Appreciate community help..!
    Thanks, best 73

    Alessandro, i2sva


    _______________________________________________
    WriteLog mailing list
    WriteLog at contesting.com
    http://lists.contesting.com/mailman/listinfo/writelog
    WriteLog on the web:  http://www.writelog.com/