[WriteLog] Running on Writelog

[Mark Griffin]

Normally with N1MM you can designate whether you wish to run or use S&P. Of
course when running you normally hit the enter key and your transceiver
calls CQ. When someone responds to your CQ you enter their callsign and hit
enter and your transceiver sends the exchange. Once that is done they give
you their exchange and you hit enter and your transceiver sends TU and QRZ.
And then the process of calling CQ starts all over again. I see that there
are S&P memories, but don't see anything specific with regards to running.
Can anyone assist me with this?
Mark Griffin, KB3Z