[Yaesu] FT-1000MP Keyer

[George Anestis]

Steve,

	I have been frustrated by this keyer behavior, too.  Must be a 
"feature".  I have found no work-around as yet.

George Anestis

Digital Equipment Corporation
1500 Ardmore Blvd.
Pittsburgh, PA 15221
412-244-7302, DTN 422-7302
Anestis@mail.dec.com

----------
From: 	k8ej@ix.netcom.com[SMTP:k8ej@ix.netcom.com]
Sent: 	Monday, December 23, 1996 8:20 AM
To: 	yaesu@contesting.com
Subject: 	[Yaesu] FT-1000MP Keyer

With the internal keyer dot/dash weighting menu-adjusted to my
preference (more weighting on both), I decided to try some of the 
other
keyer features. I use the FH-1 Keypad to activate them.

When using the Memory feature the following occurs:  As memories are
loaded and/or played back the keying characteristics default back to
the original Yaesu settings for weighting (which is too choppy for my 
liking).  Also, the speed changes.  In addition, from that point on,
just using the keyer function with a paddle also results in the 
default
keying characteristics rather than those stored via the menus.  The
only way to restore my keyer preferences, previously set in menus
7-0,7-1,7-2, is to turn the radio off/on.

Anyone else had this experience and figured out an alternative?

Tnx/73, Steve.

--
FAQ on WWW:               http://www.contesting.com/yaesufaq.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:  	          ke7gh@contesting.com
Sponsored by:		  Akorn Access, Inc & KM9P



--
FAQ on WWW:               http://www.contesting.com/yaesufaq.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:  	          ke7gh@contesting.com
Sponsored by:		  Akorn Access, Inc & KM9P