[Yaesu] wanted source for FT 5100 PA

[Dave Maley]

Had to replace mine too.   Those that have a '5100 be careful when 
running this radio at 50W level.  It is possible to overheat the VHF
PA module.  Mine was not properly coated with heat-sink compound.
Didn't find this until warranty was done.  Not that bad to pull off 
board. 
Suggest checking Richardson Electronics.  The PA in the '5100 is a
SAV24.  It can be replaced with a SAV18, if you don't mind only
running 45W.  You will find this module is a lot less, and pin 
compatable.  Don't forget to properly apply heat-sink compound
to both VERY CLEAN surfaces.
Dave.   WA0ZZG
> From:          billybobfisher@juno.com
> To:            yaesu@contesting.com
> Date:          Sun, 14 Sep 1997 23:39:04 -0300
> Subject:       [Yaesu] wanted source for FT 5100 PA

> Hello Everyone !!
> I believe I know the answer, but here goes...does anyone know of a source
> for the 2 meter power module for a Yaesu FT5100 ???? Yaesu sells it for
> $95.00, but I would love to find another lower priced source. If anyone
> has any info please email back ....73's
> Bill Fisher /  KE4GRW
> billybobfisher@juno.com
> work # 672-0129
> 
> --
> FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
> Submissions:              yaesu@contesting.com
> Administrative requests:  yaesu-REQUEST@contesting.com
> Problems:                 owner-yaesu@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm
> 
> 

--
FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm