[Yaesu] FT1000MP low output from TRV jack?

[Juha Rantanen]

Hello

I just purchased new FT1000MP and I was about to connect LT2S transverter
from SSB electronics to MP's TRV jack, but the manual says that MP gives
only -6dBm from the TRV jack. Is that correct or typo? That's like 250uW
which isn't enough for any kind of transverter. If it's correct can I adjust
it higher to give at least 1mW or 0dBm which would be enough for LT2S?

Thanks in advance. I will appreciate all help in this matter.

73 de Juha OH6KSR


--
FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm