[Yaesu] 1000MP power, reflector?

[Tyler Stewart]

No problem Will.

There is a pot for each power level located on the audio board.  It's
located on the bottom of the radio on the PCB that runs along the back, but
the pots are towards the front of this board.  I forget how the pots are
labeled, but I think it's something intuitive.  BTW, there is no reason why
you cant use the 10 watt pot to set it for 120 watts if you dont need the 10
watt setting but would like to preserve the 100 watt setting,etc.  IE, all
three pots can be set to any power setting.

Yaesu uses 150 watts as the temporary power output to set up some other
settings during alignment, so you should be able to run 120 no sweat.  I've
actually done that to both of mine as well.

73, Ty K3MM

----- Original Message -----
From: <AA4NC@aol.com>
To: <yaesu@contesting.com>
Sent: Saturday, November 04, 2000 2:51 PM
Subject: [Yaesu] 1000MP power, reflector?


>
> I recently upgraded one of my FT990s for a 1000MP. I understand that there
is
> a seperate 1000MP reflector. I would like to get the address for it.
>
> Also, is there any adjustment for power above 100 watts output on the 'MP?
> My 990 will do 110-120 watts which drives the grounded grid amps much
better.
>
> 73,
>
> Will
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/yaesu
> Submissions:              yaesu@contesting.com
> Administrative requests:  yaesu-REQUEST@contesting.com
> Problems:                 owner-yaesu@contesting.com
>
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/yaesu
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com