[Yaesu] Band Data question

[Jerry Flanders]

I don't have a direct answer, but the information and photos concerning the 
cables required for the Quadra interface at:

http://www.qsl.net/ab4oj/quadra/w4uk.html

might help.

Jerry W4UK

At 17:40 3/20/04, Don Richards wrote:
>In the past, some errors have been found in the Yaesu manuals and I would
>like to know if my FT-1000MP Mark V manual is correct when it shows the Band
>Data connections (page 4) as follows:
>Pin 1= +13 vdc
>Pin 2= Tx gnd
>Pin 3= Gnd
>Pin 4= Band A
>Pin 5= Band B
>Pin 6= Band C
>Pin 7= Band D
>Pin 8= Linear
>Also is the drawing on page 4 correct when it shows the pinouts as one would
>see them when looking at the rear panel of the transceiver?
>
>I would appreciate a reply direct to donsay2 at cox.net