[Yaesu] G-1000 DXA calibration

Mike nf4l_NO_SPAM at nf4l.com
Sat Sep 12 15:57:33 PDT 2009

On page 8 of the manual, in item 7, there is mention of two raised 
calibration marks. My rotor has three, the one on the base and two on 
the rotating bell. The two on the rotating bell are roughly 90 degrees 
apart. One is above the mold mark (or separation) and one is below.

Which one is the correct one to use for the alignment procedure? Neither 
is aligned with the mark on the base.

73, Mike NF4L

More information about the Yaesu mailing list