[Yaesu] Fw: FT1000MP Rx Jack Isolation

[Paul Playford]

--------------------------------------------------
From: "Paul Playford" <paul at w8aef.com>
Sent: Tuesday, January 19, 2010 09:52
To: "G4GED Dave" <radiodave.g4ged at tiscali.co.uk>
Subject: Re: [Yaesu] FT1000MP Rx Jack Isolation

> I have been looking at the technical supplement and I don't see anything 
> that disconnects or grounds the RX ANT port during transmit.
>
> Not disconnecting and/or grounding the RX ANT port during transmit can 
> allow transmit rf to enter the radio via the RX ANT port creating hash and 
> garbage on your transmit signal that, without a monitor scope on the 
> transmit output, you will not be aware of, but your neighbors sure will.
>
> de Paul, W8AEF
>
> ZF2JI/ZF2TA  FO8DX/FO8PLA  8Q7AA  XZ0A  VU7RG  TX5C
>
>
> --------------------------------------------------
> From: "G4GED Dave" <radiodave.g4ged at tiscali.co.uk>
> Sent: Tuesday, January 19, 2010 07:49
> To: <jcowens1 at comcast.net>; "Yeasu Reflector" <yaesu at contesting.com>
> Subject: Re: [Yaesu] FT1000MP Rx Jack Isolation
>
>> ----- Original Message ----- 
>> From: <jcowens1 at comcast.net>
>> Subject: [Yaesu] FT1000MP Rx Jack Isolation
>>> I am wanting to transmit high power to an Inverted L on 160M on the A
>>> Connector while receiving on a separate anternna connecterd to the Rx 
>>> jack
>>> on the same band. >
>
>