[Yaesu] Yaesu and related items FS

[Ken Simpson, W8EK]

Yaesu and related Items For Sale:

Dual Band Multimode Transceiver, HF Linear Amplifier,
VX-7 Accessories, several Microphones, Wattmeters,
High Power Antenna Tuner, Communications Speakers,
HT accessories, and more


Yaesu FT-736 R, Dual Band, Multimode Transceiver:

The Yaesu FT-736R all mode transceiver incorporates up to
four band modules covering the 50, 144, 220, 440 and
1200 MHz amateur bands. It is supplied with 2 meters and
440 at 25 watts output. This radio has conveniences such
as IF shift, IF notch, keypad entry, noise blanker, all
mode VOX and three-speed AGC. The memory system includes
100 general purpose memories, 10 full duplex cross-band
memories and 1 call channel, all of which store mode and
frequency.

Features:
All Mode
Keypad Entry
100 Memories
IF Notch
IF Shift
Dual Digital VFO's
Semi Break-in CW
All Mode VOX
Built-in Power Supply
10 Duplex Memories

This particular unit works 100% and looks like new. It
includes the optional tone unit for subaudible tone encode
and decode, and the 600 Hz CW filter. It is still in
its original box, with paper work for $750.


Amp Supply LK-500 Z A, HF Amplifier:

The LK-500 is an HF amp that runs a pair of 3-500 tubes, on
the 160 thru 10 meter bands, producing close to the legal
limit. On this amp, 30 watts of drive produces about 400
watts out of the amp; 50 watts gives about 650 Watts out;
etc.

This amp has a MUCH heavier duty Peter Dahl power transformer,
and covers 160 meters. It has a excellent tuned input matching
circuit. It is a superior amplifier.

This particular amp works very well. It has a manual step
start circuit added, and the electrolytic capacitors have
been replaced. Cosmetically it looks very, very nice. I
can not find a scratch on it. It looks like new.

Since this is heavy, I would much prefer pickup in the
Ocala, FL area.

With paper work for $900.


Yaesu VX-7 accessories:

VX-7 Nifty Mini Manual
A pocket reference to all of those commands that no one
remembers! For the VX-7.  Spiral bound.  $18

Programming cable
This cable has the threaded connector as used by the VX-7,
but it can also be used on the VX-6, 5, 3, etc.  Uses USB port.
It works great with the free "Chirp" program.  I have not
tried it with others. $18


Yaesu YD-148 Dual Impedance Desk Microphone:

The Yaesu YD-148 is a very nice "goose neck" type desk microphone.
It has both high and low impedances, which can be selected by a
switch. This means it can be used on some of the older rigs
requiring a high impedance mic, or with the more modern rigs
needing a low impedance mic.

This particular mic is in very nice condition. It works 100%.
With round 8 pin connector for $85.


Yaesu MH-15 DTMF Touch Tone Microphone:
The MH-15 c6 is a hand microphone that features a 16 digit
DTMF Touch Tone Pad on the back, along with a lock/unlock
switch.  The top has up/down buttons.  Of course the PTT
is on the side.  This one has the round 6 pin connector.
It works fine and looks close to new.  $40


Yaesu YM-17 hand microphone:
The YM-17 is a hand microphone with up/down switches on
the top corner.  It has the round 6 pin connector.
This one works fine and looks really great.  $30


Yaesu YM-31 hand microphone:
The Yaesu YM-31 is a hand mic with a round 6 pin
connector. Apparently it is either similar or the
same as the MH-25A6j (not the MH-25 with the 8 pin
connector). It is a 600 ohm impedance hand microphone,
and has a Monitor on-off switch on the back.
It looks very similar to the Yaesu MH-1.
This one works fine and looks extremely nice. $25


Foot Switch:

This foot switch appears to be cast aluminum,
and fairly heavy duty. It has a 1/4 inch plug
on it, as used by most foot switches, and as
is provided for on most of the Heil cords.
The cord is about 4 feet long, and is rubber
covered. $15


MFJ 815 B Cross Needle Peak Reading HF Wattmeter:

The 815 B covers from 1.8 thru 54 MHz (160 thru 6 meters),
and features a cross needle display that reads forward
and reverse power simultaneously.  Of course this means
that SWR is displayed at the same time.  The scales
are 300/3000 Watt forward and 60/600 Watt reverse.
It will read peak or average power, selectable by a
switch. 12 V DC is needed for the lighted meter.

This particular unit works fine, and looks very
close to new.
With paper work for $65.


MFJ 984 Versa Tuner IV High Power Antenna Tuner:

MFJ says this will handle 3000 Watts PEP. Since the legal
limit is half of that, you should be fine at legal power.

It covers 1.8 to 30 MHz with 250 pf 6kv caps and matches
anything you want to throw at it, or so it seems.
It also includes an RF ammeter at the output of the tuner
so you know how much actual RF current you are putting into
the antenna. There's a wattmeter/swr bridge built in along
with a small dummy load.

It has rugged heavy-duty construction. Switches are rated for
2000 Volts and 17 amp carry capacity. There's a 4:1 balun and
real ceramic feed through insulators.

This particular unit works fine. The case looks very nice.
There is slight wear on the front panel, and one small scratch
that you can see if the light is just right.

Paper work is included for $200.


Communications Speakers:

Realistic 21-549 A
This one is about 4 inches square but only about 2 inches
deep. It is rated for 5 watts, has an 8 ohm impedance, and
is listed as a 300 to 3000 Hz frequency response, making it
ideal for communications. 3.5 mm (1/8 inch) mono plug. It
is black in color, looks great, and sounds great. $18

Vanco SPB-5
Appears to be the same at above, but with a Vanco label.
Also includes gimbal mount. $15

Vanco SPB-6
Similar to SPB-5 above, but is considered a noise
cancelling speaker. 10 Watt rating. Still in original
box, new. $18


Low Pass TVI Filters:

A low pass TVI filter is added to the transmitter to reduce
harmonic interference. All have SO-239 connectors, and are
50 ohm filters.

The first one works on 6 meters as well as HF:

Drake TV-5200-LP Low pass TVI filter
This is the filter that may also be used on the low end of six
meters, as well as HF. It is good for 1000 Watts "average" below
30MHz, and about 200 W up to 52 MHz. It is the newer version
of the TV-1000. $30

Bencher YA-1, high power, low pass TVI filter
If you need a heavy duty filter for the output of your amplifier,
this one is ideal. It will take full legal power plus, and has at
least 80 db signal attenuation at TV channel 2. This one works
great, and is in its original box.
Bencher currently sells these for about $90. Only $60.

Bencher YA-1
As above, not in original box. $45

B & W FL-10/1500
This filter cuts off just above 10 meters, and handles 1500
Watts. It is the latest model B&W filter.In very nice condition,
it looks close to new. $40

Johnson 250-20 Low Pass Filter
This is a 52 ohm cylindrical low pass filter with a cut
off frequency of 45 MHz and 75 db of attenuation.
It is rated to take 1000 Watts of AM, or 5000 Watts
PEP SSB. With mounting bracket. $30

Para Dynamics PDC 1089
This filter is rated at a full Kilowatt, up to 30 MHz.
5 x 6 x 2 inch black box, instead of the more familiar long
enclosure. It looks like new. $25


Yaesu HT Accessory Items:

Belt Clip for Yaesu FT-207, with hardware. $8

Wrist Strap for Yaesu FT-209, and others $4


Rubber Duck antennas for your HT:

All are for 2 meters, are in good condition,
and are $10 each, unless stated otherwise.

BNC - Original Alinco EA0024, about 4 inches long

BNC - Original from Kenwood TH-215, about 5 inches long

BNC - "Stubby" about 4 1/2 inches long

BNC Connector - Standard, about 7 inches long

Type F connector - 6.5 inches long

BNC Stubby for 440 MHz, 3 inches long

Not a Rubber Duck, but can be used on your HT:
Telescoping Antenna w/ BNC about 19 inches long
can be used as a quarter wave antenna on
2 m, or on 220, or 450 MHz if telescoped shorter.
$12


I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, and many miscellaneous accessories.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400