[Yaesu] Yaesu large 6 pin rotor connector

[Dick Merryman]

Thanks Tom, I've been needing one of those.  The connector body is very low-melting point plastic rather than phenolic so you have to be very careful when soldering to the pins or you'll end up with loose pins like I did.

73,
	-Dick-
	N3XRU

-----Original Message-----
From: Yaesu [mailto:yaesu-bounces at contesting.com] On Behalf Of Tom-W3FRG
Sent: Saturday, January 28, 2017 08:14
To: yaesu at contesting.com
Subject: [Yaesu] Yaesu large 6 pin rotor connector

If your Yaesu rotor controller uses the old, large Cinch type, 6 pin connector with pin #1 rotated 90° check this out.



Look up eBay :   Item # 252698972053


GL  Tom   W3FRG
_______________________________________________
Yaesu mailing list
Yaesu at contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu