[Yaesu] Yaesu Items FS
kenw8ek at gmail.com
Sun Mar 11 13:38:19 EDT 2018
Crystal filter, linear amp interface box, hand mic,
programing software/hardware, and manuals For Sale :
Yaesu XF-8.2M-601 Crystal Filter:
The XF-8.2M-601 is used in the 8.2 MHz IF of many
Yaesu transceivers, including the FT-102, FT-747,
FT-757, FT-767, and possibly the FT-1000 series.
I was told it would work in the FT-1000 but have
not been able to confirm that, so please check
The 600 hz bandwidth is ideal for CW, but it is
also great for RTTY and other digital modes,
including FT-8, PSK-31, etc.
This one works fine. It looks fine also, as if
that matters for an internal filter. It is a
"solder in" filter. Only $70.
Yaesu FRB-757 Linear Amp T/R Relay Switch Box:
Many of the modern rigs are not capable of switching
the higher currents and voltages of the transmit
receive relays of some linear amplifiers. This small
box was made by Yaesu to remedy that situation.
Although it was made for the FT-757, it can be used
with almost any rig that needs a heavier relay to
switch the linear amp. It does not even need to be
a Yaesu rig.
This box needs 13 V DC (and has an RCA phono plug
for that purpose), and is connected to the rigs
linear amplifier relay output with another RCA phono
plug. The output of the box has both normally open
and normally closed contacts, both terminated in
RCA phono jacks. Contacts are rated at 600 VA AC,
150 W DC load, and will switch up to 250 volts and
up to 5 amps.
This one works fine and looks fine. Only $40.
Yaesu MH-1 B8, Hand Microphone:
The MH-1 is the standard hand mic used on most
modern Yaesu radios. It has a round 8 pin
connector on it. The mic itself has up, down,
and FST buttons on the top, to permit one to
change the frequency. On the back is a tone
switch to permit one to slightly alter the
frequency response of the mic.
If your Yaesu transceiver uses a round 8 pin
connector, this mic should work for you.
This one works fine, and looks fine as well.
RT Systems ADMS-1802 Software/hardware:
The ADMS-1802 consists of a hardware cable, plus
a software CD, plus instructions to program a Yaesu
These days the rigs have so many memories plus other
features, that it is almost impossible to program them
manually. The ADMS-1802 takes care of this problem
for the Yaesu FT-1802.
This unit appears that it might be new. Everything is
included -- Software CD, Cable, and instructions. Also
included is the serial number to make the software work.
This retails for $48.95. Buy this one for only $30.
Original Yaesu Manuals:
These are the manuals only. All are originals, and not copies.
Most are in close to new condition.
FNB-9,10,11,12 Battery packs, $2
FT-720 R, 2 meter mobile, $8
FT-1802 M, 2 meter mobile, $12
FTH-2005 HT, $5
FTS-8 tone squelch unit, $3
FTS-12 tone squelch unit, $3
MH-1B A2B speaker microphone, $2
SP-101 P, Speaker / Phone patch, $5
VX-1 dual band HT, $10
YC-601 digital readout, $10
These are original Yaesu operating manuals only,
in very nice condition.
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
Just too many to list here. Please e-mail your requests.
Prices do not include shipping from Florida.
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400
More information about the Yaesu