>I have a bad (burned) band switch on my Heath Kit SB-1000. I think it is
>the same part as the Ameritron AL-80A. Actually only the back gang is
>bad. Any suggestions where I can get a replacement gang or complete
>switch.
>
>Thanks John
>KO4A@juno.com
>
What is the measured resistance of the 100 ohm VHF parasitic suppressor
resistor, John?
Did the bandswitch first arc when the amplifier was mistuned?
I would like to measure the voltage withstanding ability of the unarced
contacts on the toasted SB-1000 bandswitch. If you are agreeable, I will
pay the round trip postage. If this is ok with you, do I have your
permission to put a photograph of the bandswitch on my Web site, along
with the withstanding voltage measurements, and give you full credit--
just in case I get sued by the amp's designer?
Rich---
R. L. Measures, 805-386-3734, AG6K
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|