Amps
[Top] [All Lists]

Fw: [AMPS] Anode load line calculations.

To: <amps@contesting.com>
Subject: Fw: [AMPS] Anode load line calculations.
From: measures@vc.net (Rich Measures)
Date: Tue, 22 Dec 1998 06:42:09 -0800
>
>In message <19981221185213.AAA303@[209.239.238.117]>, Rich Measures
><measures@vc.net> writes
>>
>>>Both - but what's the difference?  An amplifier set up to give 100W using a
>>>2000V supply or a 1kW amp using the same ht have the same requirement.  
>>
>>?  The requirement is seemingly set by the conditions under which the 
>>amplifier is tuned up.  Assuming 60% effiency, if a 1666w input, w. 2000v 
>>anode supply, 1000w-out amplifier is, , tuned up at 1666w input, approx  
>>0.833a of anode current is required.  Therefore RL is roughly. 2000v/(2 x 
>>0.833a) = 1200 ohms and the Pi-network tank circuit must be tuned to 
>>match 50 ohms to 1200 ohms.  Assuming that the drive level is susequently 
>>reduced until the output is 100w, the anode-V swing is reduced and the 
>>anode-I swing is also reduced.  In my opinion, when the output of this 
>>amplifier is 100w, RL does not become 22k-ohms. 
>
>It definitely does not. Very simplistically, reducing the drive reduces
>the grid voltage swing which reduces the anode current swing (Ia is
>related to gm x Vg); the reduced anode current swing through RL means
>less anode voltage swing.
>
>> .  However, if it were 
>>decided to tune up the amplifier for operation at 100w out, RL would 
>>increase to roughly 22k-ohms.  
>>
>>>The point I was trying to make, and which you are conveniently ignoring, is
>>>that the RL in either case is radically different if you use the formula I
>>>posted previously.
>>>
>>Semi-agreed.  .  However, the RL formula is an approximation that applies 
>>for the power level at which an amplifier is tuned.  When drive is 
>>reduced to a tenth, RL does not  increase ten-fold.  .    
>
>RL is set by the antenna impedance and matching network settings. If you
>don't retune the matching network, RL can't change.
>
?  amen, Steve


Rich...

R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures  


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • Fw: [AMPS] Anode load line calculations., Rich Measures <=