Amps
[Top] [All Lists]

R: [AMPS] Silver Plating question

To: <amps@contesting.com>
Subject: R: [AMPS] Silver Plating question
From: G3SEK@ifwtech.demon.co.uk (Ian White, G3SEK)
Date: Mon, 20 Sep 1999 22:36:23 +0100
Mauri wrote:

>I've more than some doubt if available copper is really a
>better conductor than silver plating.
>
>Under my eyes, a big power commercial VHF/FM amplifier
>prototype  was on test and the tuned line, a bare copper
>machined from a single piece, heated quite a lot. The same
>line, after silver plating, didn't develop any abnormal heating.
>
QRO is a good test - any losses are easy to notice. It seems like the
available silver plating really was better than the available copper
(and probably neither was "textbook pure"). 

>I can report a brand new (bright, shining) copper VHF cavity,
>part of a duplexer, had a certain bandwidth and attenuation.
>The same cavity was then silver plated. The bandwidth
>decreased toghether the attenuation.
>
>The same was done in a similar cavity but UHF, the difference
>was markedly bigger.

OK, I'll cheerfully revise my opinions when presented with good evidence
- there's no shame in that.

73 from Ian G3SEK          Editor, 'The VHF/UHF DX Book'
                          'In Practice' columnist for RadCom (RSGB)
                           http://www.ifwtech.demon.co.uk/g3sek

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>