Amps
[Top] [All Lists]

[AMPS] Surge voltage, HV connectors.

To: <amps@contesting.com>
Subject: [AMPS] Surge voltage, HV connectors.
From: w.knol@niwa.cri.nz (Wilbert Knol)
Date: Thu, 2 Mar 2000 08:56:47 1300
Thanks for reading this message.

 I am in the process of nutting out a HV supply for an old homebrew valve 
amplifier and have a couple of questions for the old hands.

1. The amp uses 2 x TB 2.5-300, which are rated at 2.5 kV.
The test bench version of the supply is a setup that uses microwave oven 
transformers charging a capacitor bank. It surges to 2.8 kV (under bleeder 
load only). Under 400 mA of load (the projected total plate current), the HV 
drops to 2.1 kV. Can I expect problems with the 2.8 kV at the start of a 
transmission or should I ignore the surge voltage?

2. The HV supply will be an external, stand-alone unit. I am having problems 
locating suitably rated HV connectors. The HV connector would have to be a 
two pole type, making B- before making B+, and rated at >2.8 kVDC (to 
prevent the operator from being electrocuted)

The ARRL handbook mentions Millen 37001 HV connectors. Are there any 
places that sell these (or other suitable connectors) mail order in small 
quantities? Are the Millens any good for what I want?

Ideally I would like an HV connector with a set of extra contacts for carrying 
mains to the amplifier filament transformer as well. Also I am considering an 
interlock cct preventing the HV supply from being turned on unless the 
amplifier is hooked up. This would safeguard against a live dangling HV 
connector. This requires a a pair of HV rated contacts and 5 extra contacts 

Any pointers to suitable connectors would be greatly appreciated.

Wilbert, ZL2BSJ


--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>