Amps
[Top] [All Lists]

[AMPS] HV Fusing / Diode Protection

To: <amps@contesting.com>
Subject: [AMPS] HV Fusing / Diode Protection
From: 2@vc.net (measures)
Date: Mon, 12 Jun 2000 11:04:47 -0700
>
>I have used the Metal Oxide resistors available in Digi-Key (Panasonic and
>Yageo) for the same purpose.  They are flame retardant and handle high surge
>currents.
>
But not this much surge current. 

>0.82 ohms is listed as a stock value in 2 watt rating.  High voltage may arc
>across the small body when open but that's still preferable to the short
>circuit situation.
>
An arc has only about 20v drop across it.  Thus, in a 2500V circuit,  it 
hardly limits current at all.  A glitch resistor must be robust enough to 
suffer no damage during a major fault.  Thus, the 0.82-ohm, 2w glitch 
resistor is Not good engineering practice.  A 10-ohm 10w ww glass coated 
resistor is much more suitable for glitch R duty.  With more than 3kV, 
place two such resistors in series to distribute the V burden.  

later, Steve
>
>
>--
>FAQ on WWW:               http://www.contesting.com/FAQ/amps
>Submissions:              amps@contesting.com
>Administrative requests:  amps-REQUEST@contesting.com
>Problems:                 owner-amps@contesting.com
>
>


-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>