In my case the switch was damaged by accidently rotating it while diping the
plate. Wrong knob...
-----Original Message-----
From: measures <2@vc.net>
To: Ian Roberts <ITR@Nanoteq.co.za>
Cc: AMPS <amps@contesting.com>
To: <amps@contesting.com>
Date: Friday, September 22, 2000 1:41 AM
Subject: Re: [AMPS] wanted SB 220 bandswitch
>
>>
>>If a spare is floating around, please contact me, I need one.
>>
>>Cheers,
>>Ian ZS6BTE
>>
>Km1H, Carl Heuther is a source of SB-220 bandswitches. His e-mail adr is
>km1h@juno.com. If the contacts on your orig. bandswitch vapourized, it
>might be a good idea to decrease VHF gain before you *fire* the amp. up
>with a new bandswitch. // Save the old bandswitch as a source of fixed
>contacts. Drill the rivets. Use #0-80 brass hardware to fasten the
>replaced contact. Silver-solder after the nut is snug.
>>--
>cheers
>>
>
>
>- Rich..., 805.386.3734, www.vcnet.com/measures.
>end
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/amps
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|