Amps
[Top] [All Lists]

[AMPS] Tube going bad?

To: <amps@contesting.com>
Subject: [AMPS] Tube going bad?
From: w7ti@dslextreme.com (Bill Turner)
Date: Sun, 19 Aug 2001 05:38:23 -0700
I have a Commander HF-2500 which uses a pair of 3CX800's.  Recently I've
noticed the plate current does not drop back all the way to zero when
un-keying.  The longer it's on and the hotter it gets, the higher this
current is.  It starts out around 50 ma and after a half hour or so of
RTTY, will get up to 250-300 ma.  If I let it sit with filaments on but
not keyed, eventually the current will drop down again.

I'm suspecting some out-gassing in one or both of the tubes.  I know the
previous owner seriously overheated the tubes to the point where the
delrin insulators around the tubes were melted.

Does this sound like a bad tube or tubes?  

Thanks in advance,

73, Bill W7TI

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>