Amps
[Top] [All Lists]

[AMPS] Reverse-engineering design plate HV

To: <amps@contesting.com>
Subject: [AMPS] Reverse-engineering design plate HV
From: jflanders2@home.com (Jerry Flanders)
Date: Thu, 15 Nov 2001 13:12:35 -0500
Thanks. ARRL handbook indicated that blocking capacitor voltage rating 
should be about 2x the plate supply, but I didn't know if commercial specs 
would agree.

It must have been about 4KV. I have to come up with a supply to power it 
with to check it out. I should be able to use the 3500V available in my 
AL-1200 to make sure all the amp's components are good before buying PS 
components to build a separate supply for it.

73

Jerry W4UK

At 07:10 AM 11/15/2001 -0800, 2 wrote:



> >
> >In an old 5CX3000A 1.6-32MHz amp I am working on, the plate blocking caps
> >are rated at 8KV. Can I guesstimate from this what plate voltage was
> >intended?
>
>//   Eimac rates the 5cx5000A at 7kV in 24/7 AØ or FM.  8kV in SSB
>service should be ok.  The rated scrren potential is 1000v max.  To
>utilize the 5cx5000A's c. 6.5A-pk emissive ability, anode and screen
>potential should be maximal. The 8kVDC  blocker-C rating sounds adequate.
>  5kVDC vacuum caps are ok with up to c. 3000v-pk at 32MHZ.  This suggests
>that the TMC anode-PS was roughly 4000v.  For SSB use, I would consider
>removing the resonant filter -choke, converting to a C-filter, raising
>the screen potential.  P-out should then be about one standard 6db S-unit
>better than a SB-220.    To run it at c. 1500w, tune it up at full
>throttle - then back down the mic. gain until the anode-I barely wiggles.
>  Increase mic. gain as needed to maintain communications.
>
> >It was made by TMC, presumably to commercial or military specs.
> >
> >If it helps, it has vacuum variable caps in the tank rated at 5KV.
> >
>cheers, Jerry
>
>-  R. L. Measures, 805.386.3734,AG6K, www.vcnet.com/measures.
>end
>
>
>--


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>