Amps
[Top] [All Lists]

e: [AMPS] AL1500

To: <amps@contesting.com>
Subject: e: [AMPS] AL1500
From: paulc@mediaone.net (Paul Christensen)
Date: Fri, 7 Dec 2001 14:13:40 -0500
> Just tested that too. The circuit is a bipolar transistor sampling grid
> current, into a CMOS trigger that drives the cathode bias relay. There
> is a 1 millisecond delay on the input to the transistor, to prevent
> nuisance triggering, and the data sheet for the relay (nothing special,
> a regular Potter & Brumfield / Schrack RTE240xx 8 amp power relay) says
> the break time is 2 ms.

Quite impressive actually...even without an accelerating circuit.

> The important thing is that the delay of an electronic trip can be only
> a few milliseconds for *all* levels of overload. This is what an
> electronic trip can do, but a fuse can not!

Ian, very interesting results!

Another interesting possibility is the use of an opto-isolating 
photo-transistor (e.g., GE H11A2 or 4N32) to develop the required
isolation between the cathode sample point and the remaining portion of the 
trip/reset circuit.  In the Alpha 77 example, the
photo-diode side of the isolator could be coupled across the 3.3-ohm emitter 
resistor.   I believe the approximate isolation rating
for many of the garden-variety, low-end devices is ~ 7KV DC and cost less than 
25-cents in quantities.

-Paul, W9AC



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>