Amps
[Top] [All Lists]

[AMPS] Chassis for HB Amps

To: <amps@contesting.com>
Subject: [AMPS] Chassis for HB Amps
From: stevek@jmr.com (Steve Katz)
Date: Wed, 2 Jan 2002 10:58:59 -0800


> You say --
> 
> >I found a local sheet metal shop that has CNC LASER
> >metal cutting equipment.
> 
> Such a deal!  Do they do mail-order work?  Maybe they should ...
        [Steve Katz]  No, I seriously doubt it.  Why would they?  If you
have CAD software (even AutoCAD, which is a very inexpensive program) and
can download the CAD files to them via the internet, this saves setup time;
however, cost for shipping 16ga CRS chassis can exceed the cost of the
chassis themselves in many cases, and complicates the review/approval
process.  However, everywhere I've lived (NJ, CA and points between, even
the Florida panhandle) has sheet metal shops listed in their Yellow Pages,
and many modern shops use 100% CNC equipment, and many of them also have at
least one CNC LASER.  The Amada LASERMAC (I think it's called) is only the
size of a turret punch, uses the same programming language, and in very
popular use in most of the shops around these parts...

        WB2WIK/6

> I had not considered the higher tech methods for panel fabrication such as
> laser, EDM, and water-cutting.  Maybe I should have.
> 
> I think there might be a tidy little mailorder business for one-off,
> quick-turn panel cutting.  I can think of some projects I've done that I
> would have gladly forked over a dead Andrew Jackson for somebody else to
> hog out the holes.
> 
> Jim N6OTQ
> 

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>