>
>> There are ways to design around this problem, but the only reliable
>> way is to use a higher-rated device and/or a lower rail voltage.
>
>.......or to clamp the shunt side of the series resistor with a large
>zener with a capacitor across. You can use a zener clamp rated
>below the maximum voltage breakdown of the shunt device, and
>above the highest desired regulated voltage.
>
>This actually is a good idea in ANY case, because the shunt diode
>with protect the screen system if the main regulator goes on
>vacation.
// Why not use a simple zener-string shunt regulator and obviate the
needless complexity?
- R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
www.vcnet.com/measures.
end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|