Amps
[Top] [All Lists]

[AMPS] Shunt regulated high voltage psu

To: <amps@contesting.com>
Subject: [AMPS] Shunt regulated high voltage psu
From: bjk@ihug.co.nz (Barry Kirkwood)
Date: Wed, 30 Jan 2002 20:35:48 -0000
And presumably if one has screen overcurrent protection the screen supply
will close down if there are no anode volts.....
end
Barry Kirkwood PhD ZL1DD
Signal Hill Homestay
66 Cory Road
Palm Beach
Waiheke Island 1240
NEW ZEALAND
www.waiheke.co.nz/signal.htm
----- Original Message -----
From: Steve Katz <stevek@jmr.com>
To: 'rich' <2@mail.vcnet.com>; Steve Thompson <g8gsq@qsl.net>; AMPS
<amps@contesting.com>
Sent: Wednesday, January 30, 2002 7:48 PM
Subject: RE: [AMPS] Shunt regulated high voltage psu


>
>
>
>
>
> > //   Sounds good.  How did you protect the screen from loss of anode
> > potential?.
> >
> ::That's a simple one: I didn't.  In my case, the tube is the fuse.
> However, in 25 years, this problem has never occurred.  The screen, plate,
> grid and filament supplies are all on the same chassis, through the same
> power cord, using the same circuit breaker, so will all die quickly in the
> event of AC failure.  Other than that, it's been pure luck, which I seem
to
> enjoy plenty of.
>
> -Steve WB2WIK/6
>
> > cheers, Steve
> >
> > -  R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
> > www.vcnet.com/measures.
> > end
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
>
>



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>