Re: [Amps] Zero Crossing circuit

[Will Matney <craxd1@ezwv.com>]

Bill,

To me, as long as it keeps the inrush current down to an acceptable 
level, it's okay with me. If you don't hear that big thump, something is 
doing its job I would think. I've never had any experience with zero 
crossing circuits so I cant comment that much. I just understand the 
theory behind them. All I do know is that step start works to reduce it. 
The only way to tell for sure is measure the peak "on" current that's 
drawn. If it's okay, then the components wont get jarred as hard.

Best & 73's

Will Matney


Bill Turner wrote:

> On Wed, 17 Nov 2004 16:19:47 -0600, Phil Clements wrote:
>
>  
>
> > Zero crossing circuits (solid-state relays) are far too fast acting 
> > for use as a soft-start device, Ed.
> >
> > A properly designed soft-start circuit has a delay equal to the time 
> > it takes the H.V. meter to reach 2/3 of the way to its normal reading.
> >    
>
> _________________________________________________________
>
> I must disagree.  My Command HF-2500 uses zero-crossing solid state
> devices to turn on and they work perfectly.  There is no thump, no
> noise, and the turn-on is smooth as silk.  Other than those devices,
> there is no soft-start circuit of any kind.
>
> --
> Bill W6WRT
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> __________ NOD32 1.880 (20040928) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.nod32.com
>
>
>
>  

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps