Amps
[Top] [All Lists]

Re: [Amps] Magnet wire stripper

To: <Amps@contesting.com>
Subject: Re: [Amps] Magnet wire stripper
From: "Will Matney" <craxd1@ezwv.com>
Date: Sun, 27 Feb 2005 11:00:09 -0500 (Eastern Standard Time)
List-post: <mailto:amps@contesting.com>
 Mark,

We used those when I was in Vo-Tech back in the early 80's to strip magnet
wire leads on transformers and motors. The other day, the closest thing I
could say they looked like was a huge pair of toe nail clippers  without the
lever. Once you get used to them, it dont take no time and the varnish is
scraped off. If the lead was long enough, you could use a knife and lay the
wire down on a block of wood or something. Just use the knife to scrape the
enamel off the same way. Where it will be a soldered connection most of the
time, a little copper loss dont hurt a bit. Copper loss, meaning a very
small amount, if any, with the enamel once you get used to using them.

Best,

Will
 
-------Original Message-------
 
From: Mark - AA6DX
Date: 02/26/05 08:17:02
To: Will Matney
Subject: Re: [Amps] Magnet wire stripper
 
Hey Will ... like that one.  I work a lot with enameled wire .. I am going
to get one of the Ideal strippers and give it a whirl.   Tnx Info ... 73 ..
Mark, AA6DX
 
----- Original Message -----
From: "Will Matney" <craxd1@ezwv.com>
 
 
 
> The other day someone asked about a magnet wire stripper.
 
 
 
__________ NOD32 1.999 (20050215) Information __________
 
This message was checked by NOD32 antivirus system.
http://www.nod32.com
 
 
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>