Amps
[Top] [All Lists]

[Amps] Homebrew 4-1000 problems

To: amps@contesting.com
Subject: [Amps] Homebrew 4-1000 problems
From: Richard Sisson <wa4mif@mindspring.com>
Date: Fri, 26 Aug 2005 07:54:52 -0500
List-post: <mailto:amps@contesting.com>
New to the list and need help. First I will list the problem(s) and list 
what I have in the amp. This is my first and last homebrew project so I am 
not an expert with the math.
1. main problem is a blue glow at the bottom of the tube  ONLY when keyed, 
drive or no drive.
2. 7.2 MHZ tune up the plate choke gets hot, burning wire 
smell.....measures about 84-87 uh.
3. blue glow in tube on any band. when keyed.
Now here are the specs:
5000 vdc no load, 4300 vdc full load, 600ma, center tap full wave with 16 
mf filter caps, 117k bleeder resistors.
Tube is cathode driven with a pi network on the input. The grid and screen 
pins are to ground. There is a 7.5 v zener in the cathode metering circuits 
and a relay that cuts the tube off when in idle mode, a 15k resistor is 
across that. Plate idle current is about 200 mils, with 125 watts drive on 
75 meters will give me about 650-700 mils on the plate---ZERO grid current, 
and about 1350 watts out measured with a Bird Thruline meter. 150 watts of 
drive, 1800 out. I have 0 grid  all the time, is my bias meter circuit 
wrong or what. I know this is not much info but I can figure out most 
problems, but the blue glow has me baffled. Yes i have several tubes and 
they all do the same, so its not a "bad tube". The input circuits have been 
tuned for minimum swr on the bands 1.5 or less. Now the filament choke is 
very close to the input coils, could I be picking up some AC field here??
The B- goes to meter circuit through a 12 ohm resistor, I get no reading on 
the grid meter, I should have a little grid current.....Where go from 
here.  thanks Richard


-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.10.15/81 - Release Date: 8/24/2005


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>