Amps
[Top] [All Lists]

Re: [Amps] YC-156 Triode

To: <W6RU@aol.com>, <lncarman@swbell.net>, <amps@contesting.com>
Subject: Re: [Amps] YC-156 Triode
From: "k7rdx" <k7rdx@charter.net>
Date: Thu, 8 Sep 2005 20:38:02 -0700
List-post: <mailto:amps@contesting.com>
That sounds typical of some of thr Russian triodes too...I read somewhere a
few yrs ago of a conversion to GI7B`s in a MLA-2500 . The guy had a ac hum
on the audio as well as when keyed with no drive. They corrected the problem
by transposing heater voltage from the outside of one tube to the inside
connection of the other tube,and opposite wiring for the other fil leg.They
were feeding filament voltage thru a conventional bifilar filament choke
with .01  across both fil legs/cathode for rf drive, filament trans ct for
negative return. I found the same hum problem as Terry suggests with a
single GS-35b and cured it as he did with the yc-156.Jim.
----- Original Message ----- 
From: <W6RU@aol.com>
To: <lncarman@swbell.net>; <amps@contesting.com>
Cc: <k7rdx@charter.net>
Sent: Thursday, September 08, 2005 7:24 PM
Subject: Re: [Amps] YC-156 Triode


>
> In a message dated 9/8/2005 5:56:31 P.M. Pacific Daylight Time,
> lncarman@swbell.net writes:
>
> My  filament transformer didn't have a center-tap
> so I improvised a B- by using  an artificial centertap made of diodes
> connected
> to each leg of the  filament's secondary.
>
>
> This tube is NOT a directly heated cathode. It has a indirectly  heated
> cathode ... connection to the cathode is the outside heater  connection.
This is
> where you connect the B- through a RF choke to the tube. I  found that any
other
> B- connection to this tube will induce hum in the  transmitted signal do
to
> the AC heater current ending up in series with the  cathode B-.
>
> Terry W6RU
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>