Amps
[Top] [All Lists]

Re: [Amps] What blower?

To: craxd1@verizon.net
Subject: Re: [Amps] What blower?
From: R.Measures <r@somis.org>
Date: Sun, 29 Jan 2006 03:13:53 -0800
List-post: <mailto:amps@contesting.com>
On Jan 28, 2006, at 8:09 PM, Will Matney wrote:

> We had discussed using the new infrared aimable thermometers for this. 
> You aim the laser dot and read the temp. I was thinking Rich Measures 
> was going to try this out using a Fluke model.

I bought an IR thermometer at Costco® for c. $70.   The accuracy is 
semi-good when comparing it to a
Weston dial thermometer.

> If it was a sucess, I would like to know the outcome. I myself though 
> of using one to check the coil temperatures on transformers running 
> under full load. The outter coil temp can be used to extrapolate the 
> internal temp at the mean radius of each coil this way. Has anyone 
> tried this with any success yet?
>
> Best,
>
> Will
>
>
> *********** REPLY SEPARATOR  ***********
>
> On 1/28/06 at 8:00 PM Bill Turner wrote:
>
>> ORIGINAL MESSAGE:
>>
>> At 11:35 AM 1/28/2006, Gary Smith wrote:
>>
>>> Top of my one of my 3cx800 a7's reads 73 degree at idle in standby
>>> Temp of tube key down 145 degrees. 1kw in rtty out.
>>
>>
>> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>>
>> The top of the tube is not especially critical. It's the seal
>> wherever metal meets glass or ceramic that counts. If you can reach
>> that with the tube operating, fine. Many rigs you can't.
>>
>> 73, Bill W6WRT
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>

Richard L. Measures, AG6K, 805.386.3734.  www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>