[Top] [All Lists]

Re: [Amps] glass tape scotch 27

Subject: Re: [Amps] glass tape scotch 27
From: "Will Matney" <>
Date: Wed, 14 Jun 2006 08:37:15 -0400
List-post: <>
I'm not being sarcastic, but simply asking a question. Again, what's the use in 
using a tape that I would think could be replaced with something much cheaper 
for us poor folks. Not everyone in the US has a brief case stacked full of Ben 
Franklins to apply to a project. This question was directed at everyone that 
responded that they were using it, not just a single person. Sarcasm, social 
ignorance? The very thing the Admin just posted about I do think, and I'll 
about bet not one word will be said about it.........


*********** REPLY SEPARATOR  ***********

On 6/14/06 at 6:08 AM tim jenkins wrote:

>sarcasm is a sign of social ignorance, i dont think they have a pill for
>> From: "Will Matney" <>
>> Date: 2006/06/13 Tue PM 02:31:22 EDT
>> To:
>> Subject: Re: [Amps] glass tape  scotch 27
>> What I'm wondering is why one would need a tape rated at 130 C (266 F)?
>The core should not get no where near that hot, maybe just warm to the
>touch which would be around 100-110 F (37.7-43.3C). Ferrite supposed to be
>non-conductive which would only leave sharp corners which can be removed
>easily with a piece of emory cloth if they have them. You can also place a
>wood dowell through the center of the toroid and use a wire brush wheel on
>a grinder to remove them very quickly from the O.D.. I generally just keep
>a piece of emory cloth on the bench and smooth them that way. It don't
>take too long to do it. I've seen many cores, both iron powder (which most
>has a painted coating), and ferrite without tape that has lasted for
>years. I wouldn't doubt that regular tape like the filament tape I
>mentioned would work just fine. Matter of fact, I know a company that used
>that tape to install the RF power meter in an amp which was mounted where
>the tubes were close, and heat actually mel
>>  ted the meter back when the fan quit. The tape was still ok. I cant see
>one vibrating enough to cause this either. If it does, something like the
>blower or fan is way out of balance, and ought to be replaced. The newer
>varnishes on magnet wire is pretty tough, especially if it has Teflon
>insulation like Teflon hook up wire. On toroids, you need all the space
>you can get to hold the wire if it will be a good amount, so a thin tape
>ought to be used if possible like Kapton. That is if any need be used at
>all like a good amount which does not. On input tune cores, tape means a
>lot of space where they are small. On output tank coil toroids for 80 or
>160 meters, I've seen both taped and non-taped used. I just can't see
>where this expensive tape would be needed here for this purpose.
>> Best,
>> Will
>> *********** REPLY SEPARATOR  ***********
>> On 6/13/06 at 7:14 AM tim jenkins wrote:
>> >scotch 27 is high temp with thermosetting pressure-sensitive ashesive
>> >operates at class b 130 deg C ( 266 deg F) temp.  tim kv4bk
>> >scotch 27 glass cloth electrical tape
>> >
>> >kv4bk @ amps4u
>> >
>> >_______________________________________________
>> >Amps mailing list
>> >
>> >
>> _______________________________________________
>> Amps mailing list
>kv4bk @ amps4u

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>