1100 or so on 10m, 1400ish on 75. I dont have a 160m antenna, so I never tried
it on that band... Definitely could've been meter accuaracy issues since it
was low on the high bands and higher on the low bands, but that is also not
atypical for that amp with the measures mods. And over a kW is PEE-Lenty on
10m... If you can't do it with that power level, another kW probably won't
help much.
I replied to the fils question off-list in a hurry, but they were high as well
because of the high line voltage (like 5.8V!!!!). I installed the Measures
thin teflon wire mod and dropped it to about 5.2V or so. I don't remember
exact voltages as it's been a while, and I've sold the amp...
Joe
----- Original Message ----
From: Gudguyham@aol.com
To: n3ji@yahoo.com
Sent: Monday, July 17, 2006 5:37:46 PM
Subject: Re: [Amps] output of SB220 typical TSPA
In a message dated 7/17/2006 2:22:56 P.M. Eastern Standard Time,
n3ji@yahoo.com writes:
I was getting approximately 1100-1400W PEP on SSB out of my TL-922
(depending on band) with fresh 3-500ZGs and 245V+ line V with 100W drive,
FWIW.
Joe, N3JI
IN that range is probably somewhat accurate with 1400 being high and
somewhere in the middle being just about as expected. Lou
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|