Amps
[Top] [All Lists]

Re: [Amps] B&W 852 Impedance Measurements

To: Bob Maser <bmaser@tampabay.rr.com>
Subject: Re: [Amps] B&W 852 Impedance Measurements
From: "R.C. Morris" <robrk@nidhog.net>
Date: Thu, 03 Jul 2008 12:11:07 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Maybe someone moved the taps.
One of Bill Orr's handbooks talks about moving the taps on the 851.
Forget if also the 852. Whatever you end up for Pz, one of the taps may 
be OK, but they don't follow for the other bands.

I have a pair of 3-500's at 3800 volts with an 851. After 20 years, I 
forget what band was good, but moved at least three others and replaced 
the 10 meter coil.

Figure your plate Z, check the charts, and I think you will need a big 
solder tool.

Bob Maser wrote:
> The B&W 852 that I bought arrived today and is in good condition.  I took 
> some inductance measurements for each of the band positions and found that 
> all of them are low as compared to what I thought they should be.
> 
>             Original Specs                Actual measurement
> 
> 10            .95 uH                                   .61 uH
> 15            1.34                                       .96
> 20            2.34                                     1.67
> 40            3.72                                     2.56
> 80            7.00                                     5.41
> 
> My measurements were made on a AADE unit which has always been very 
> accurate.  The 852 was not mounted on the aluminum chassis, just sitting on 
> a wooden bench.  I cannot see any signs of alteration, it all looks stock.
> In order to use this 852, the Q would be between 15 and 20, very sharp 
> tuning.  The Original specs correspond to a PLI of 2000 with a Q of ±12.
> 
> Any comments would be appreciated.
> 
> Bob Maser  W6TR 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>