Amps
[Top] [All Lists]

Re: [Amps] Thoughts on half-wave dipole

To: AMPS <amps@contesting.com>
Subject: Re: [Amps] Thoughts on half-wave dipole
From: "Dr. David Kirkby" <david.kirkby@onetel.net>
Date: Mon, 28 Jul 2008 17:14:15 +0100
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Jim Brown wrote:
> On Sun, 27 Jul 2008 20:10:42 +0100, Dr. David Kirkby wrote:
> 
>> I wish to know if the reactance of a dipole that is physically 0.5000 
>> wavelengths in length depends on the diameter of the wire or not.
> 
> So study a book on antennas! It is very well known (not far from the 
> beginning of the discussion in almost any text) that the physical length of a 
> resonant conductor depends on its cross section. There are many excellent 
> texts on antennas, including the one by Kraus. The ARRL Antenna Book is also 
> quite good. Both are widely available new and used. And yes, it is quite far 
> off topic for this list. 
> 
> This sure sounds like a troll, but for a hot minute, let's pretend that it 
> isn't. :) 
> 
> The confusion here is between a wavelength in air (or free space) and a 
> wavelength in the conductor that makes up the antenna. When we decide how 
> long the antenna should be, we're concerned with the wavelength in that 
> conductor, not the wavelength in free space. When we design for the spacing 
> between elements of a parasitic array (like a Yagi), we are concerned with 
> the wavelength in free space. 
> 
> 73,
> 
> Jim K9YC
> 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
schelkunoffhalf.jpg

I've stuck another graph up, which shows the indepdance better around 
0.5 lambda. The point of intersection of the lines if j 41.2 Ohms.


http://www.g8wrb.org/schelkunoffhalf.jpg

Also see the other one I posted

http://www.g8wrb.org/schelkunoff-full.jpg


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>