All great advice!
Hell, I wish there'd been an Amps Reflector when I built my first multiband HF
amp. In fact, I wish there'd been an internet! :-)
cheers
Dave G0OIL
--- On Sun, 30/11/08, Robert Groh <rgroh@swbell.net> wrote:
From: Robert Groh <rgroh@swbell.net>
Subject: Re: [Amps] how to measure tank
To: "Jerry K" <w5kp@hughes.net>, amps@contesting.com
Date: Sunday, 30 November, 2008, 3:50 PM
One thing to keep in mind - the input impedance of a GG amplifier is strongly
influenced by the output tuning of the amplifier and the output levels of the
amplifier. Hence the suggestion that checking the input VSWR should be done
with the amplifier loaded into a dummy load and all tuned up at nominal
operating conditions.
73
Bob Groh, WA2CKY
Blue Springs, Missouri
________________________________
From: Jerry K <w5kp@hughes.net>
To: George Badger <gbadger@sbcglobal.net>
Cc: amps@contesting.com
Sent: Sunday, November 30, 2008 9:10:45 AM
Subject: Re: [Amps] how to measure tank
I have a question about the other end of an amp. I don't own a monitor,
but could an MFJ-259 be used to tweak the bandswitched input tuning
coils of an AL-811 by sweeping the input (while keeping the keying relay
manually closed)?
Jerry W5KP
George Badger wrote:
> Lynn
> Put a resistor from plate ground to simulate the load and look into the
output with an MFJ 259. Tune for a match. Works like a charm.
> George W6TC
>
>
> ----- Original Message ----
> From: Lynn Osterbur <no9z@yahoo.com>
> To: amps@contesting.com
> Sent: Saturday, November 29, 2008 6:50:47 PM
> Subject: [Amps] how to measure tank
>
> I am starting to forget all I know!
>
> Components Homebrew amp and cushman service monitor
>
> What is the proper way to measure a pi network with a tracking generator
and spectrum analyzer.
> I am mostly interested in the connections to the tank circuit.
>
> using cushman 5100 with tracking generator and spectrum analyzer. I
havent used it for
> 3 or 4 years and that was on a set of 2m bandpass filters. I also assume
that I will need to
> put a load resistor across the tube equal to the load resistance.
>
> Lynn NO9Z
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|