Brief & to the point- they stink, monoband or (worse) tapped bandswitch
"models". They may be fine for the occassional SSB QSO without pushing it, but
otherwise they do one thing with regularity- they die/burn out/self-destruct.
RTTY? WSJT & other digicrap with 100% duty cycle for 30-55 seconds key-down?
Result? Be ready for a buzz, hiss, POP & Boom & to buy a new amp, or parts
that cost enough $ to build a new one. I don't do any digital myself save cw
but if you want a list of dead SB200 conversions (owned by others) I'll be
happy to provide them, some were EME deaths & others that just "crapped out"
due to tubes that aren't ment to be used at that QRG.
I don't care what you can "get away with", I want something that isn't
going to crap out because the tubes aren't rated for 50MHz use. SB200s should
be left to HF. If you are still going to convert one, do what I am doing and
put a 3CPX800 in it with new cooling and a new FWB PS and appropriate
transformer. Otherwise build one with an appropriate tube/s from scratch which
I have also done x 3. 572Bs are a lousy tube for 6m conversion unless your
habit is to run it a few hours per year.
Oh, one last thing- for parasitic suppressors, don't be lazy and use the
resistor leads as a soldering surface for the L (really a "U") between resistor
sides on a 6m conversion. I have seen 4 cases so far of that method resulting
in heat melting the "L" on the plate-block side... ergo all B+ plus RF current
passes thru the resistors & softens the tubes in seconds. $600+ $ down the
tubes.
N3DB
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|