Amps
[Top] [All Lists]

Re: [Amps] Question: Ship Vacuum Variables at minimum or maximum?

To: James R Carr <n7fcf@hctc.com>, amps@contesting.com
Subject: Re: [Amps] Question: Ship Vacuum Variables at minimum or maximum?
From: Robert Groh <rgroh@swbell.net>
Date: Sat, 13 Jun 2009 21:58:35 -0700 (PDT)
List-post: <amps@contesting.com">mailto:amps@contesting.com>
That sound's like a good idea with one added proviso - the cap inside has to be 
kept isolated (as much as possible) from shocks and vibration. But I do like 
the idea of the rigid (yet fairly inexpensive) idea of the PVC tubing.  Vac Cap 
set a minimum, a layer of bubble wrap (with big'ish bubbles) around the vac 
cap, the whole thing stuff in a large hunk of 4" PVC piping and the whole thing 
in a good box with peanuts or more bubble wrap and one should be good to go.

Thanks to all for the ideas.

Bob Groh, WA2CKY




________________________________
From: James R Carr <n7fcf@hctc.com>
To: Pete Lancashire <pete@petelancashire.com>; amps@contesting.com
Sent: Saturday, June 13, 2009 5:44:53 PM
Subject: Re: [Amps] Question: Ship Vacuum Variables at minimum or maximum?

The sure way to beat the united gorillas is to pack it like a fishing pole. 
A short length of pvc tubing of the right diameter with a couple of end cap 
caps fastened on with sheet metal screws. pad it well, and they can't crush 
it by running over it with a truck.
Jim
N7FCF
----- Original Message ----- 
From: "Pete Lancashire" <pete@petelancashire.com>
To: <amps@contesting.com>
Sent: Wednesday, June 10, 2009 10:35 AM
Subject: Re: [Amps] Question: Ship Vacuum Variables at minimum or maximum?


>I would toss in, neither. If anything go to fully min or max
> and then back off a couple of turns.
>
> Also consider buying a double or triple wall corrugated box,
> if I was the buyer I would be glad to pay the cost.
>
> -pete
>
>
>> ORIGINAL MESSAGE:
>>
>> On Wed, 10 Jun 2009 07:59:23 -0700 (PDT), Robert Groh
>> <rgroh@swbell.net> wrote:
>>
>>>
>>>Comments and advice welcome. The vacuum variables are Jennings UCS and
>>> UCSL, by the way, if that matters.
>>
>> REPLY:
>>
>> That's a very good question Robert, but I think the best way is to
>> pack them so well it doesn't matter. I'm not trying to be a smarty
>> here, it's just that they are so delicate in any configuration that
>> you can't hardly have too much foam around them. The box should be
>> many times larger than the capacitor and well stuffed.
>>
>> 73, Bill W6WRT
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>