K1TTT wrote:
>>
>> Picked up an amp the looks like its been around smokers.....Any thoughts
>> on best way to try and clean up most of the tar / residue?
>>
Use a foaming cleaner that has been specifically formulated for the
electronics industry, so it (probably) won't attack most common
materials used in electronic equipment.
(Foaming shower cleaner, on the other hand, has only been formulated not
to attack the materials used in showers. For example, it is very likely
to contain acids to dissolve limescale, which an electronics cleaner
wouldn't.)
In Europe, Servisol Foam Cleaner 30 is good. Data sheets are here:
<http://uk.farnell.com/servisol/100002000/cleanser-foam-gp-30-400ml/dp/38
21572>
Buy a LARGE can, and prepare for a horribly messy job involving LOTS of
kitchen towel, toothbrushes etc, as Carl describes.
I once cleaned up an SB-220 that was so nicotine-stained, the metal
discs on the control knobs had turned from aluminum to gold! The state
of the fan was indescribable...
>A flame thrower comes to mind... or maybe an ultrasonic cleaner full of
>gasoline. That is tough stuff and you can be sure it is down in every nook
>and cranny of the amp.
>
It also oxidizes into a hard, insulating film. Contacts that have been
left open for a long time are going to need special cleaning. Again, use
a cleaner that has been specially formulated for the job.
--
73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|