Yep, I've done it and it cleared the fault ok. Only problem is that I
am now too chicken to test the tube in the amp.
73, Alek.
VK6APK
At 02:54 AM 10/09/2009, TexasRF@aol.com wrote:
>Has anyone tried to blow a grid to cathode short with a high current pulse
>of energy? Such as touching the shorted pins for an instant with a car
>battery. At this point seems not much to loose by trying.
>
>73,
>Gerald K5GW
>
>
>
>
>In a message dated 9/9/2009 1:46:57 P.M. Central Daylight Time,
>royanjoy@ncn.net writes:
>
>About:
>
>
>"...No visible damage to the case, but now when the amp is turned on, but
>in
>standby, the plate current reads about 200mA and the grid current is
>pegged
>negative. Plate voltage is lower than what it used to be, about 2600 V.
>Switching between RX/TX doesn't seem to have any affect, I can hear the
>relay kick. One final observation, in RX, one tube starts to glow orange,
>while the other stays the normal light yellow color...(etc.)"
>
>
>My ZB had that happen several times when using Eimac tubes AND before I
>installed a good in-rush protection circuit plus ridded it of parasitics.
>Never has occured since (with RFP tubes). It's surely a grid - to - fil
>internal short.
>
>73, Roy K6XK
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
http://www.qrz.com/vk6apk
http://www.qrz.com/vk6py
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|