[Top] [All Lists]

Re: [Amps] Need bushing

Subject: Re: [Amps] Need bushing
Date: Mon, 5 Oct 2009 22:22:21 EDT
List-post: <">>
If you have a drill press and vise, you can make one in a few minutes. A  
one inch section of a .75" bolt makes the donor material. Drill through the  
center .25" and then drill again half way .375" diameter. Set screws can be  
added by drilling one side and tapping 6-32 or 8-32.
A .25" bolt and nut makes a nice mandrel to chuck the piece in the drill  
press for smoothing the ends and removing burrs.
Gerald K5GW
In a message dated 10/5/2009 8:34:26 P.M. Central Daylight Time, writes:

Ampers:  Looking for a bushing to adapt 3/8"shaft to 1/4"...Needs to be 
solid not a  flexible coupling..If anyone has such and will part with it please 
contact me  off list..Many  thanks..Jim..K7RDX..
Amps  mailing  list

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>