Paul Gerhardt wrote:
> Thanks for all the comments on the Blower restrictor. It will stay off for a
> while. The reason for it although not obvious to me at first is Very
> Obvious when you look at it from a safety viewpoint.
IF you want a "keppen da fingers out" type of cover, look at the fan
grids used in computers. They exist in sizes from about 80 mm up
through 140 mm, are inexpensive, cause little restriction, and work well.
> You can more easily
> put your finger into the blower without the plate in place, that is the only
> possible reason that I can think of....It is staying off and hopefully is
> the reason for the melting solder on the filament pin sleaves.
> One to the next problem ....SB-230 and Clipperton-L
> Paul K3PG
> Amps mailing list
Amps mailing list