[Top] [All Lists]

Re: [Amps] Henry 3K up and running!

To: "'Donald Fox'" <>, <>
Subject: Re: [Amps] Henry 3K up and running!
From: "Dave Harmon" <>
Date: Mon, 19 Oct 2009 18:15:07 -0500
List-post: <">>
That?s great Don.....that's a great amp.
I bought a 3K-A new from Henry in Los Angeles in early 78' and everything
was fine till 80' when the power supply went to ground.
I went over to the factory to inquire about a replacement......they said it
was out of warrantee.
I asked who was the original mfgr and was told that their transformers were
made in the LA area somewhere in or near Orange County and that in his (the
tech I was speaking with) opinion, this transformer mfgr wasn?t very good
and Henry was using them only because of the cost of the cheap.
The mfgr had an Indian name....not American Indian.
So....I bought the choke from Dahl and installed it.
Haven?t seen it since.


Dave Harmon
Sperry, Ok.

-----Original Message-----
From: [] On
Behalf Of Donald Fox
Sent: Monday, October 19, 2009 2:24 PM
Subject: [Amps] Henry 3K up and running!

As it turns out, A1 Motor Rewinding in Park Hills, Ky. (859-291-1351) was
able to sucessfully repair the existing xformer. Diagnosis was part of the
secondary winding arcing to the core near the rear upper left corner. 
They were able to add some insulation, and then dip and bake the unit.
The bill was $200 total, and the staff there was very receptive to my
A fellow named Nick who is a ham (WB4BB) is on staff, and I feel that he
took personal interest in the repair due to our ham radio connection.
I would certainly recommend them for any such issue. Bill is another
contact, and although not a ham, was very helpful.
Bill did say that while transformers are not their "bread and butter", they
have repaired and also rewound quite a few of them successfully.

Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
Amps mailing list

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>