Amps
[Top] [All Lists]

Re: [Amps] HV Connectors

To: amps <amps@contesting.com>
Subject: Re: [Amps] HV Connectors
From: Ron Youvan <ka4inm@tampabay.rr.com>
Reply-to: ka4inm@tampabay.rr.com
Date: Sun, 23 May 2010 22:41:38 +0000
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Barrie Smith wrote:
> Some time ago, there was a thread concerning HV connectors and HV wire.
> I did not pay too much attention at the time, because I had no needs,
> Things have changed, and I find myself building a small amp for 10 and 15M, 
> only (My HB 10 through 160 has never worked on 10 or 15).  The HV will only 
> be 2 KV.
> I found the thread, but it appears to be one of those that went in all 
> directions.
> I think the post that caught my attention was one by (I think) Bill, W6WRT.  
> He mentioned a connector that was similar to a BNC where the ground had to be 
> made before the HV was connected.
> I'd like to know what they are and where to get them.

   The most important thing that I learned is to put the connector on the power 
supply end of the 
interconnecting cable so if it is not connected there can not be a wire with 
high Voltage on it 
rambling around.
-- 
    Ron  KA4INM - The next election, I know what is going to happen, I'm going 
to help.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>