Amps
[Top] [All Lists]

Re: [Amps] adding fan to Clipperton L

To: <amps@contesting.com>
Subject: Re: [Amps] adding fan to Clipperton L
From: "Mike" <noddy1211@sbcglobal.net>
Date: Fri, 28 Jan 2011 11:55:28 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Exhaust fan, sucks in from the top and blows out the back.

Mike, K6BR

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Roger (Sub1)
Sent: Friday, January 28, 2011 11:30 AM
To: amps@contesting.com
Subject: Re: [Amps] adding fan to Clipperton L

On 1/28/2011 9:52 AM, Carl wrote:
> More air wont hurt but how hot is hot? The existing fan can also be sped
up
> by reducing the value of the 330 Ohm series resistor.
>
> Remember a basic rule.....fans cause noise as air flow increases.

Is that fan supposed to exhaust air, or blow it in?  Seems as if I 
remember it blowing in, but it has been a long time..

73

Roger (K8RI)
> Carl
> KM1H
>
>
> ----- Original Message -----
> From: "Paul Manuel"<k4pdm@yahoo.com>
> To:<amps@contesting.com>
> Sent: Friday, January 28, 2011 9:21 AM
> Subject: [Amps] adding fan to Clipperton L
>
>
>>
>> Do you guys think it would be a good idea to add a fan pushing air into a
>> Clipperton L, either above the tubes or on the right side of the cabinet?
>>
>> As it is, the single exhaust fan on the back allows the tubes to get
>> awfully hot during a long-winded QSO.
>>
>> 73&  Thanks, Paul K4PDM
>>
>>
>>
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>